Make any sense? help please! sounds like somethings not in order hereĬalm down. $This program is the property of Microsoft Corporation. WARNING: The A20 Line was already enabled. WARNING: The High Memory Area is unavailable. WARNING: Shadow RAM is in use and can't be disabled.$ĮRROR: This HIMEM.SYS is for Windows NT.$ĮRROR: An Extended Memory Manager is already installed.$ĮRROR: HIMEM.SYS requires an 80x86-based machine.$ĮRROR: No available extended memory was found.$ĮRROR: VDISK memory allocator already installed.$ WARNING: Shadow RAM disable not supported on this system.$ REM is zero, EMM will be disabled and the EMM line will be ignored. REM with your application or _default.pif). REM The EMM size is determined by pif file(either the one associated REM allocate all possible and available UMB for page frames. REM and leave the rests(if available) to be used by DOS to support REM space from the Upper Memory Block(UMB) area for EMM page frames REM specifies that the system should only allocate 64Kb address REM The value must be given in Hexdecimal. REM memory you want the system to allocate for EMM page frames. REM specifies the starting segment address in the Dos conventional REM specifies the total Alternative Mapping Register Sets you REM You can use EMM command line to configure EMM(Expanded Memory Manager). REM MS-DOS-based applications can be started, add the command dosonly to REM application, any running TSR may be disrupted. If you start an application other than an MS-DOS-based REM By default, you can start any type of application when running REM rather than COMMAND.COM, add the command ntcmdprompt to CONFIG.NT or To run CMD.EXE, the Windows command prompt, REM MS-DOS-based application, Windows runs COMMAND.COM. REM When you return to the command prompt from a TSR or while running an REM the command echoconfig to CONFIG.NT or other startup file. To display CONFIG.NT/AUTOEXEC.NT information, add REM By default, no information is displayed when the MS-DOS environment REM different startup file is specified in an application's PIF. REM CONFIG.NT is used to initialize the MS-DOS environment unless a REM CONFIG.SYS is not used to initialize the MS-DOS environment.
0 kommentar(er)
